Typical Properties


Pack Size:                
                   0.5 kg
                      1 kg
Ceramic in brushable grade for protection of process equipments against bimetallic corrosion, cavitation and pitting.
Ceramic in brushable form for protective coating
Application Instructions :(Please read general instructions)

Surface Preparation : Better the surface preparation, better the application life.For best adhesion, the application surface must be clean, rough, dry and free from all loose particles, oil, grease, etc., Abrade using conventional tools or sandblast to SA 21/2 standard to expose actual base substrate.Apply Conditioner for cleaning and degreasing of components.

Mixing: Resin and Hardener are supplied in pre-weighed packs and in different colours for visual inspection of complete mixture.For part mixing take Resin : Hardener in the ratio of 1 : 1 by volume or weight. Mix homogeneously until uniform colour is obtained. Scrap sides, corners and bottom of containers.

Application : Apply mixed materials with suitable stiff type brush. The 1st coat must be firmly applied and be well scrubbed in to the surface. The 1st coating should be allowed to become tack free, before applying the 2nd coat. As for as possible the coating should be applied on bare surface only. Surface temperature should be ambient at the time of application. The more number of coats will give higher degree of insulation. No solvents or thinners should be added. Dry finish will produce textured finish, if the roughness is absent, then Heat insulate has not been stirred properly.
#3, 1st Cross, Netaji Circle, Mathikere Ext. Bangalore - 560054,     Email: unnathigroups@gmail.cominfo@unnathi.com,   unnathicare@gmail.com    Phone: 080 - 23604570 
Mobile : +91 9986004163,    +91 9845554959
This site is designed and hosted by  www.karnatakawebmart.com, Bangalore.
PH: +91 80 23606148, Email: contact@karnatakawebmart.com
Copyright Unnathi Groups, All Rights Reserved