Extremely eassy to clean, seamless hard wearing epoxy floor coat that produce attractive aesthetic resistance to abrasion and to a appearence. Ideally suited for areas where high degree of cleanliness are required. Exceptional wide range of chemicals.
SELF LEVEL EPOXY FLOORING
Self leveling epoxy floor coating for High Impact and A bression Resistant
Application Instructions :(Please read general instructions)
Surface Preparation : Surface to be coated must be structurally sound, dry, free from loose material. All surface contamination must be removed. Grease and oil should be grit blasted or water jetted. Deeper penetration must be removed by mechanical means.
Mixing: Contents of Resin and Hardener should be throughly stirred individually to disperse any settlement which may taken place during storage. The entire contents of Hardener should be poured into Resin and the materials thoroughly mixed for atleast 3 minutes taking particular care to scrap the sides and bottom of the container. Mechanical mixing using a slow speed (300-400 rpm) electric drill fitted with mixing paddle is preferable. Follow mix ratio for part mixing.
Application : The material is poured onto the prepared substrate and spread to the required thickness with a steel trowel, slowly and evenly. Immediately after spreading on floor compound should be firmly rolled with a spiked nylon roller to release any entrapped air in the material and level slight trowel marks.